Wet Location, Corrosion-Resistant Emergency Lighting Unit
Availability : In Stock
Product Type : Wet Location Emergency Lighting
Vendor : Wet Location Emergency Lighting
SKU : ESW-EML-WLH
The Exit Sign Warehouse ESW-EML is ideal for wet locations, resistant to corrosive atmoshperes, non-hazardous dust environments, and to water spray, splashing water, or hose down locations. The adjustable halogen lamps are enclosed in a fully gasketed, corrosive resistant fiberglass enclosure designed to withstand the harshest environment. The solid-state charging circuit features short circuit and overload protection for years of reliable use. Wet location listed, resistant to corrosive atmoshperes, non-hazardous dust environments, and to water spray, splashing water, or hose down locations
Fully gasketed enclosure
Fully adjustable 5 watt halogen lamp heads
Optional G2 self-test/self diagnostics available
Automatic brownout protection
Contractor friendly, snap-together design
AC lockout feature reduces installation time
Wall or ceiling mounted
UL 94-5VA flame rating
120/277V dual primary 60Hz input
Low voltage disconnect
1 year warranty
ETL Listed (conforms to UL924)
90 minute emergency run time
Sealed momentary test switch
Maintenance-free sealed lead-acid battery
Enclosure is constructed of precision molded fiberglass, resistant to corrosive atmospheres. Fully gasketed clear polycarbonate cover encloses lamps and reflectors, and offers protection against wet, non-hazardous dust, and hose down locations.
Units come standard with two fully adjustable MR-16, 6 volt, 5 watt halogen lamps.
Dual voltage, 120 volt or 277 volt input. Circuit provides automatic brownout, short circuit, and overload protection. A sealed momentary test switch and LED charge indicator are included.
The circuit continuously monitors the operating condition of the AC power, battery supply voltage, emergency lamp continuity, and charging circuit. If failure occurs, visual status will occur immediately via the multi-colored LEDs. LED indicator(s) will illuminate until fault has been corrected. The G2 also monitors the transfer circuit as well as performing automatic code compliant testing. The self-test will operate the equipment in emergency mode five minutes every 28 days. Also, a 90 minute full-function test is performed every six months.
Maintenance-free, sealed lead-calcium battery provides an estimated service life of 10 years with an operating temperature range of 19oC to 30oC (65oF to 85oF).
120/277 VAC dual voltage input with surge protected, solidstate charging circuitry provides for a reliable charging system. The charging system is furnished with low voltage disconnect, AC lockout, brownout protection, AC indicator lamp and test switch. The low voltage disconnect (LVD) feature will disconnect the battery prior to an unacceptable deep discharge, but not before the required 90 minute emergency operation. The AC lockout feature prevents battery drain prior to the initial energizing of utility power, and allows the installer to complete all wiring and electrical connections without energizing the emergency circuit. The brownout protection circuitry will automatically switch the unit into the emergency mode if the utility voltage sags below 20% of nominal. Battery charging circuitry is entirely solid-state, and utilizes a constant current charger for sealed lead-calcium battery units. Battery recharge time after full discharge is less than the required UL 924 standard. Line sensitive electronics cause an instantaneous transfer to battery power if utility power is lost, or a brownout condition is detected. When line voltage is present and stabilized, the transfer circuitry switches back to normal operation and begins recharging the battery. The transfer circuitry can be tested via a momentary test switch located on the housing.
The LL50H-N4 Series meets or exceeds all performance standards as required by UL 924, NFPA 70, NFPA 101, NEC and OSHA.
Length 14.75" Height 5.75"